訪客您好!歡迎來到 3DANIMS.COM

登入系統: ID:  密碼:   

3DANIMS.COM 討論區

 Lighting, emboss and recess text effect!

  • Laurent
  • 一般會員
  • Hong Kong
  • 註冊日期:2005年8月21日02時08分
  • 發表文章數:5篇
2005年10月3日11時10分
Why the images no gradient color on the surface after rendering?
Is there any mistake on light setting?
Moreover how to make emboss or recess text effect on the surface?

I'm fresh man on this software hope somebody can help me.
Thanks again.

Freelance designer from HK.

以下是此留言的附圖:附件檔

  • 站長
  • 台灣 台北市
  • 註冊日期:2004年2月13日21時02分
  • 發表文章數:1145篇
2005年10月3日17時10分

Laurent 於 2005年10月3日19時10分 寫道

Why the images no gradient color on the surface after rendering?
Is there any mistake on light setting?
Moreover how to make emboss or recess text effect on the surface?

I'm fresh man on this software hope somebody can help me.
Thanks again.

Freelance designer from HK.


i think the problem is your model has lighting on the front surface directly...also, the value of the lighting you've used is way over.

if you wanna make your model embossed...you'll need to make the model edge beveled. There is a tool named "Bevel" you can find it under the Multiply>Extend>Bevel...just select the front face polygon then hit on the Bevel tool to make it... that's it!!!
目前您的時區設定為(GMT +8:00 hours) 北京, 香港, 伯斯, 新加坡, 台北

©2010 Timax Media co., All Right Reserved.

建議使用 Internet Explorer 8+ 或 FireFox 3 以上之瀏覽器

建議解析度為 1024 x 768 pixals x 24 bits

目前系統當地時間為 2024年3月28日19時03分09秒

所有本站提供之圖案、影像、文字皆屬時空影像媒體製作有限公司版權所有,未經本公司同意,禁止任何形式之轉載或轉貼。

Website Forum Developed, Designed and Mantained By 張智龍(Frankc)